Why can't I ignite it?？
1。Ignition needle is not ignited
answer：Check the power，The burner is installed in place，Note position of ignition electrode and gas source error，Wet，Ignition needle or pulse igniter damage。
2。Whether the machine matches the gas source
answer：Check if the gas source for the machine brand name matches the existing gas source（Liquefied cylinder should be0。6Fixed pressure reduction valve）
3。Air loop is not connected
answer：Check if the gas source has been connected to the gas，Whether the valve opens。
4。The ignition tank of the furnace is not aligned，Ignition needle or ignition
answer：Penaged with ignition for accurate or cleaning ignition tank。
5，Electromagnetic valve is broken
answer：Check the solenoid valve or replace the solenoid valve。
Why is the flame when burning?？
1。Road is not clear
answer：Check if there are foreign matter in the gas pipeline， Waiting for cleaning pipeline。
2。Gas mass difference or abnormal pressure
answer：Whether the gas source pressure is abnormal？The gas in the cylinder is about to finish，Replace gas cylinders or contact gas companies。
3。Burning part is moist or blocked
answer：Check if there is watermark or foreign matter on the burner，Pack up
4。The throttle is not adjusted to the best position
answer：Conditional door，Direct to the best location。
Why is the cigarette effect?？
1。Exhaust pipe is not smooth
answer：Check if the exhaust pipe is deformed or bending too much，Blocking，Clean up foreign objects or re-adjust exhaust pipes
2。The anti-stroke door is not fully opened
answer：Check the wind door，Or replace the damper。
3。Furnace cavity suction mouth blockage
answer：Is there a suction port of foreign body blocked cavity？Unchecked foreign matter。
4。Fan wind speed is abnormal
answer：Check if the fan speed is abnormal or replaced by the motor。
What if the fan does not start?？
1。Fan universal
answer：Check that the voltage on the power board is normal，Or replace the power board。
2。Motor temperature is too high
answer：The motor is highly temperature rise，After cooling It will automatically move back。
3。The capacitor is broken.
answer：Replace capacitor。
How to automatically extinguish after ignition？
1。Pulse lighter is broken
answer：More pulse igniter。
2。No flames were detected on the ion detection needle
answer：Check if the fire hole of the lid is blocked，Use sharp tools to dred。
3。Ion detection needle lines fall off
answer：Check if the detection line is disconnected，re-install。
Cleaning cabinet can't work？
1。The entire machine is not powered
answer：Check if the power supply power supply is normal or replaced。
2。Gate switch is not closed or damaged
answer：Check if the door control switch is in place or replaced。
Is the induction cooker work?？
1。Pot is not pure iron pot
answer：Replace pure iron 易彤破壁机哪款最好 or induction cooker。
2。The diameter of the pot does not meet the requirements
answer：Replace the needed pot according to the instructions。
3。Damage of the main board or operation board of the induction cooker
answer：Replace the motherboard or operator board。
If the display is displayed“ EO”And issue an alarm sound，what to do？
1。The gas is abnormal in the room
answer：Open the fan and doors and windows，Abnormal gas，And check if there is gas leak，And maintenance。
2。Control board damage
answer：Replace the control board。
3。The sensitivity of the gas sensor is too high
answer：Replacement of low sensitivity gas sensor。
Why don't have a power supply?（Display is not bright）？
1。The entire machine is not powered
answer：Whether the lost protection plug is closed？Whether the power cord is damaged or replaced。
2。Power board fuse is damaged
answer：Replace the same type of fuse
3。Unplug the control board or power
answer：Replace the control board or power board。
